Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
SB2501
Service Bulletin/Repair Instructions
The control arms of the front and trailing axles are equipped with a flexible ball-joint at the chassis side. Van Hool has several suppliers for the repair kit of this flexible ball-joint. All of the repair kits contain a flexible ball-joint, a spacer and a snap ring. Due to not equal thickness of the spacer in the different kits, it is important to install all three the kit parts when replacing a flexible ball-joint. Do not mix parts of different repair kits!
SB2497
Service Bulletin/Repair Instructions
Mobile column lifts raise the vehicle under the wheels. This service bulletin is a reminder about the usage of mobile column lifts when lifting a complete vehicle.
SB2262B
Service Bulletin/Repair Instructions
TO CHECK EMERGENCY SIDE WINDOW OPERATION To ensure trouble-free operation, the emergency side windows must be checked on a regular basis. This will allow you to confirm the proper operation of the emergency exit handle and unlatching mechanism, as well as the proper installation and function of the window seals
SB2494
Service Bulletin/Repair Instructions
INTRODUCTION The purpose of this service bulletin is to inform you about the removal and installation of Raufoss line fittings
SB2468
Service Bulletin/Repair Instructions
Van Hool recently changed-over in production to a “longer” articulation shaft (VH11717611) to fasten the wheel-suspension arms to the steering knuckle carrier/hub carrier. Field experience has shown that this change-over has a positive impact on the lifespan of the rubber bushings. The “longer” articulation shaft may be used with the M18 as well as with the M20 fastening system (refer to figures 2 and 3).
SB2372B
Service Bulletin/Repair Instructions
This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the National Highway Traffic Safety Administration’s (NHTSA) Federal Motor Vehicle Safety Standards (FMVSS) in the U.S and the Canadian Motor Vehicle Safety Standards (CMVSS) in Canada about this subject.
SB2372a
Service Bulletin/Repair Instructions
This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the National Highway Traffic Safety Administration’s (NHTSA) Federal Motor Vehicle Safety Standards (FMVSS) in the U.S and the Canadian Motor Vehicle Safety Standards (CMVSS) in Canada about this subject.
SB2372
Service Bulletin/Repair Instructions
This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the National Highway Traffic Safety Administrationâs (NHTSA) Federal Motor Vehicle Safety Standards (FMVSS) in the U.S and the Canadian Motor Vehicle Safety Standards (CMVSS) in Canada about this subject.
SB2255
Service Bulletin/Repair Instructions
Service Information: In its production process, Bock, manufacturer of refrigerant compressors, has switched to a new type of motor protection switch for the electric motor of the refrigerant compressor. As the MP10 motor protection switch (VH11472802) is no longer made available as a spare part, as of now you will receive the new INT69G motor protection switch (VH11691810) when ordering. The MP10 and the INT69G are interchangeable, but fastening and electric connection are different.
SB1709
Service Bulletin/Repair Instructions
Product Improvement: ALL VEHICLES WITH LIGHT-ALLOY WHEELS - Introduction of wheel-end monitoring system (WEM). Van Hool has released a wheel-end monitoring system (WEM) which can be installed on all vehicles equipped with light-alloy wheels. The WEM is installed at the outboard side of the wheel and monitors vibrations produced by the wheel bearing. It warns in case of bearing raceway spalling by flashing a red LED on the unit. The WEM is delivered with a magnet which is used to change from "transport" to "standstill" mode.
SB1856
Service Bulletin/Repair Instructions
Service Information - Maintenance operations related to refrigerant compressor oil This service information bulletin is a reminder/update about refrigerant compressor oil maintenance. To ensure a reliable system, it is important to perform the maintenance on a regular base as mentioned further on.
SB2039A
Service Bulletin/Repair Instructions
Service Information - Introduction of new 4/2 solenoid valve in compressed-air circuit Van Hool has switched over into production to a new type of 4/2 solenoid valve in the compressed-air system. As the previous Knorr-Bremse (Bosch) solenoid valve (VH11102170) is no longer made available as spare part, customers will receive a Wabco solenoid valve (VH660526759) when ordering. Both valves are interchangeable, but some differences must be considered. Consult the information in this service bulletin for a proper installation.
SB1319
Service Bulletin/Repair Instructions
To change condenser fan relay 660752034 by relay 660762200.
SB1328
Service Bulletin/Repair Instructions
DANA, manufacturer of axles, has informed Van Hool that the procedure for checking the wheel bearing end-play has been changed.
WP-449-A
Service Bulletin/Repair Instructions
VANHOOL: INFORMATION PROVIDED FOR, INSPECTING AND CONVERTING, COACHES WITH SMALL CRACKS SHOWING IN DRIVE AXLE AREA AND GUIDELINES TO REINFORCE SEVERAL TUBE JOINTS TO ENSURE STRUCTURAL INTEGRITY OF CHASSIS REPAIR, PER MANUAL. MODEL C2045. NO YEARS LISTED. *PE
SB-1234
Service Bulletin/Repair Instructions
VAN HOOL COACHES: STARTER SOLENOID FLYBACK DIODE. ALL COACHES FEATURING MULTIPLEX TECHNOLOGY. IN THE MAIN JUNCTION BOX OF THE UNITS, MULTICONNECTOR PIN E11 OF MULTIPLEX NODE 4 (PART #10690971) HAS BEEN CONNECTED TO THE STARTER MOTOR SOLENOID GROUND. OVER TIME THIS NODE MAY EXPERIENCE ISSUES FROM AN EMF SPIKE FROM THE STARTER MOTOR SOLENOID. NO MODEL YEARS LISTED. *PE
CSB-2009-001
Service Bulletin/Repair Instructions
ABC CO. (VAN HOOL INC.): COOLANT LINE SERVICE. THERE ARE 2 SECTIONS. SECTION 1 COVERS REPLACEMENT OF COOLANT HOSES AND SECTION 2 COVERS INSTALLATION OF BRACKETS FOR COOLANT LINE RETENTION. BOTH SECTIONS ARE INCLUDED IN THIS BULLETIN SO THAT IN CASES WHEN BOTH SECTIONS ARE APPLICABLE THEY MAY BE PERFORMED CONCURRENTLY AND THUS ELIMINATE REDUNDANT STEPS THAT ARE COMMON TO BOTH SECTIONS. *PE