TST 144096
Other
Upon installation of the 2-UP passenger seat, difficulty to install might result in the breakage of the latch.
Vehicle report
2020 CAN-AM RYKER
Service bulletins
16 bulletinsTechnical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
TST 137209
Service Bulletin/Repair Instructions
RYKER YAW Rate - SAS Sensor Faults These 3 faults (C0063 and/or C0051 and *C006C) can be triggered if the front suspension has excessive play or the front wheel alignment is out of specification
TST 136437
Service Bulletin/Repair Instructions
Rykers 900 engines that may have the incorrect camshaft timing. Ryker Equipped with the 900 engine may start well when cold but then can have a rough idle or even dies at idle when the engine is warmed up.
TST 140638
Service Bulletin/Repair Instructions
This TST includes solution for the noise that can be heard or felt under deceleration at high speed.
Bulletin 2023-2
Service Bulletin/Repair Instructions
This bulletin is the detailed repair procedure if the position light and flasher electrical harness in the front fenders have rubbed on the tires wearing the insulating sheath.
Message 140046
Service Bulletin/Repair Instructions
Message and alert to all dealer RYKER mandatory certification form The front wheel installation is a critical operation and must be performed as explained in the PDI bulletin.
TST-136739
Service Bulletin/Repair Instructions
Fuel Pump can be noisy especially when low fuel levels and warm temperatures.
Bulletin 2021-4
Service Bulletin/Repair Instructions
Repair Procedure Revision- Brake Light Switch Adjustment Vehicle may indicate brake light switch failure, rear brake light stays ON or flashes intermittently.
TST138262
Service Bulletin/Repair Instructions
We have some report that some 602 and 903 engines have been produced with the wrong camshaft. This document will help you to identify the correct one. If the wrong camshaft is installed the unit can have the following symptoms poor, idle, engine performance, O2 fault, engine misfire.
2020-1 Revision
Service Bulletin/Repair Instructions
Safety Campaign Revision- Wheel nut may crack. One or more wheel nuts may crack resulting in a reduced clamping force. New VINs added in the warranty campaign and new steps in the procedure.
2020-6
Service Bulletin/Repair Instructions
Safety Campaign- Possible Front Wheel Loss. The front wheel assembly may not have been performed properly (torque application and installation of the red locking clip).
Bulletin 2020-2
Service Bulletin/Repair Instructions
Vehicle may indicate brake light switch failure. One of the probable cause is the adjustment of the brake light switch/low pressure switch.
TST 137262
Service Bulletin/Repair Instructions
This technical service tips is to show how to fix some leaks coming from the coolant cap area.
TST 137241
Service Bulletin/Repair Instructions
Possible contact between the exhaust pipe and frame. Here are some ways to increase the distance between the exhaust pipe and the frame. The minimal distance between the exhaust pipe and the frame should be 5mm. Symptoms Excessive engine vibration felt, exhaust manifold bolts loose, engine rattle noise.
2020-1
Service Bulletin/Repair Instructions
One or more wheel nuts may crack resulting in a reduced clamping force. This could eventually affect the integrity of the wheel assembly and the vehicle's behavior. This may increase the risk of a crash.
PDI 137019
Service Bulletin/Repair Instructions
Ryker 2020 Low Torque on FDU The bolts that holds the FDU to the swing arm are not torqued as specification for these vehicles.
Reading this report
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.